egov.mn

Bifacial thin-film solar cells capture reflected light, turning it into electricity

Researchers at South Korea’s Daegu Gyeongbuk Institute of Science and Technology (DGIST) have developed a...

This story was prepared automatically by software.

Bifacial thin-film solar cells capture reflected light, turning it into electricity

Researchers at South Korea’s Daegu Gyeongbuk Institute of Science and Technology (DGIST) have developed a thin-film solar cell that can generate electricity from light reaching both its front and rear surfaces, including light reflected from nearby surroundings.

The device uses an antimony-based absorber and a transparent polymer rear electrode. The team also integrated it into a four-terminal tandem solar cell, combining it with a second photovoltaic material to capture different portions of the light spectrum. The tandem configuration reached a reported power conversion efficiency of 12.32%.

A transparent contact that also carries current

Bifacial solar cells are designed to collect sunlight from both sides. Their rear surface can use light reflected or scattered by the ground and nearby objects, rather than relying only on direct illumination from above. Tandem cells take a different approach: they stack photovoltaic absorbers that respond to different wavelengths, allowing them to make better use of the incoming spectrum.

Combining the approaches requires a rear electrode that lets light pass through while still collecting electrical charge. These goals can conflict. A layer that conducts electricity well may block or absorb some of the light that should reach the absorber.

The DGIST researchers addressed this problem with a solution-processed, two-layer transparent rear contact made from Spiro-OMeTAD and PEDOT: PSS. They treated the PEDOT: PSS with dimethyl sulfoxide (DMSO), an additive used to adjust the polymer’s electrical properties. According to the study, this solvent engineering reduced the layer’s sheet resistance by nearly four orders of magnitude while retaining high transparency.

Lower resistance helps electrical charges move through the contact, while transparency allows more incoming light to reach the active solar-cell material. The resulting antimony selenosulfide cell, with the chemical composition Sb2(S,Se)3, recorded power conversion efficiencies of 8.2% under front-side illumination and 3.3% under rear-side illumination.

Tandem design adds a second absorber

The team then placed the antimony-based device above a copper indium selenide (CuInSe₂) cell to create a four-terminal tandem. The two cells are electrically independent and absorb different parts of the light spectrum. Their outputs can therefore be combined without requiring the layers to share a single electrical connection.

The tandem achieved a combined power conversion efficiency of 12.32% under standard test conditions, according to the paper published in Advanced Materials. DGIST’s accompanying release also reports a bifacial power density of 18.81 milliwatts per square centimeter when the front and rear were each illuminated at one sun.

The paper’s abstract separately reports 9.7 milliwatts per square centimeter for the bifacial single-junction device under one-sun front illumination and 0.3-sun rear illumination. These figures refer to different device configurations and lighting conditions.

The results point to a way of using reflected light that conventional front-illuminated designs may not capture. However, the reported efficiencies are measurements from the developed devices, not evidence that the technology is already being used in commercial solar panels.

The researchers said they plan to improve performance by optimizing the interface between the transparent electrode and the light-absorbing layer, as well as the device’s optical structure.

The findings were published in the peer-reviewed journal Advanced Materials.

Source: https://interestingengineering.com/science/bifacial-solar-cells-light-electricity-electrode

Share
Next storyNASA’s Sentinel-6B to become global reference satellite for sea level data in January
Newsletter

Get the latest news delivered to your inbox.

Related articles